Samson XP 106 Owner's Manual page 17

Quick Start - Stage XPD1 Wireless System
If the handheld transmitter and
receiver have not been previously
paired, press and hold the button on
the RXD1 receiver for >5 seconds,
until it begins to flash.
Speak or sing into the mic at a normal
performance level and raise the
WIRELESS LEVEL control until the
desired level is reached.
XP106 • Portable PA System
Press and hold the Power button on
the handheld transmitter >5 seconds.
This will put both components into
pairing modes. Once the receiver and
transmitter communicate and sync,
the LEDs on both units will light
steady and will be ready for operation.
If you hear distortion check the rear
panel PEAK LED. If it is lit red, turn down
the WIRELESS LEVEL on the XP106
until it lights only occasionally during
loud sounds. If you still hear distortion,
unscrew the microphone body and use
the supplied plastic screwdriver to turn
the Gain control in the HXD1 transmitter
slowly counterclockwise until the
distortion disappears.
Conversely, if you hear a weak, noisy
signal at the desired volume level (and
with the WIRELESS control of the XP106
turned fully clockwise), use the supplied
plastic screwdriver to turn the Gain
control in the HXD1 transmitter slowly
clockwise until the signal reaches an
acceptable level.
17