Using the Setup Program
Hard Drive Submenu
Use this submenu to configure the boot sequence for hard drives.
Table 17.
Hard Drive Submenu
Options
•
Installed hard drive
•
Bootable ISA Cards
Removable Devices Submenu
Use this submenu to configure the boot sequence for removable devices.
Table 18.
Removable Devices Submenu
Options
•
Installed hard drive
•
Bootable ISA Cards
Exit Menu
Use this menu to exit the Setup program, save changes, load defaults, and save defaults.
Table 19.
Exit Menu
Feature
Exit Saving Changes
Exit Discarding Changes
Load Setup Defaults
Load Custom Defaults
Save Custom Defaults
Discard Changes
48
Description
Specifies the boot sequence for the hard drives attached to the computer. To
specify boot sequence:
1.
Select the boot device with <↑> or <↓>.
2.
Press <+> to move the device up the list or <-> to move the device down
the list.
The operating system assigns a drive letter to each device in the order listed.
Changing the order of the devices changes the drive lettering.
Description
Specifies the boot sequence for the hard drives attached to the computer. To
specify boot sequence:
1.
Select the boot device with <↑> or <↓>.
2.
Press <+> to move the device up the list or <-> to move the device down
the list.
The operating system assigns a drive letter to each device in the order listed.
Changing the order of the devices changes the drive lettering.
Description
Exits and saves the changes in CMOS RAM.
Exits without saving any changes made in Setup.
Loads the default values for all the Setup options.
Loads the custom defaults for Setup options.
Saves the current values as custom defaults. Normally, the BIOS reads the
Setup values from flash memory. If this memory is corrupted, the BIOS reads
the custom defaults. If no custom defaults are set, the BIOS reads the factory
defaults.
Discards changes without exiting Setup. The option values present when the
computer was turned on are used.