Bad Boy MZ 42 Owner's, Service & Parts Manual page 29

SECTION 5: FRAME
Torque rear wheel lugs to 65-75 ft. lbs. Re-torque
at every oil change and check at every mowing.
There is one grease fitting on each of the actuator
bar pillow blocks (Total of 4).
Grease twice a season.
The pump belt tensioner is located under the
engine and has a grease fitting at its pivot point.
change.
Grease at every engine oil change.
The deck belt tensioner is located at the rear
of the deck and has a grease fitting on its
oil change.
pivot point. Grease at every engine oil change.
The control arm blocks have grease fittings
located on the top of each block. Grease one time
a year.
tension adjus a t y m e e ar n . t bolt to its most rearward position in
order to pro Grease fittings on MZ model total – 8 v G id re e a th s e e low est be on lt t MZ ens m i o on d e p l os total sibl – e. 8
fittings
the deck to its highest position. (4) Remove either the right
or left blade pulley cover. (5) While lifting up on the belt (as
shown in the photograph), rotate the pulley until the belt is
free of the pulley. Exercise caution while performing this step
as fingers can easily become caught between the belt and
PAGE 29
(3) Raise