Indoor Unit Installation - Samsung HH105ECM Installation Manual

Indoor unit installation

Place the pattern sheet on the ceiling at the spot where you want to
1
install the indoor unit.
◆ Since the diagram is made of paper, it may shrink or stretch
N N N N o o o o t t t t e e e e
slightly due to temperature or humidity. For this reason, before
drilling the holes maintain the correct dimensions between the
markings; refer to page 6.
Insert bolt anchors. Use existing ceiling supports or construct a suitable
2
support as shown in figure.
Install the suspension bolts depending on the ceiling type.
3
Ensure that the ceiling is strong enough to support
IMPORTANT
the weight of the indoor unit.
Before hanging the unit, test the strength of each
attached suspension bolt.
4 Screw eight nuts to the suspension bolts making space for hanging
the indoor unit.
IMPORTANT You must install the suspension bolts more than four
when installing the indoor unit.
5 Hang the indoor unit to the suspension bolts between two nuts.
◆ Tubing must be laid and connected inside the ceiling when
N N o o t t e e
N N o o t t e e
suspending the unit. If the ceiling is already constructed,
lay the tubing into position for connection to the unit before
placing the unit inside the ceiling.
Screw the nuts to suspend the unit.
6
Adjust level of the unit by using measurement plate for all 4 sides.
7
◆ For proper drainage of condensate, give a 10mm slant to the
N N o o t t e e
N N o o t t e e
left or right side of the unit which will be connected with the drain
hose, as shown in the figure. Make a tilt when you wish to install the
drain pump, too.
Concrete
Hole in anchor
Hole in plug
Suspension bolt(M8)-field supply
Ceiling support
10mm
Drain hose connection port
Insert
Rubber
7
E-