Drain Hose Installation - Samsung HH105ECM Installation Manual

Drain hose installation

Drain pump hose connection port
Drain hose connection port
Cable-Tie
Insulation drain
Indoor
Unit
Insulation drain
Drain Socket
pipe
C C A A U U T T I I O O N N
C C A A U U T T I I O O N N
Must fit tightly against
body without any gap.
C C A A U U T T I I
C C A A U U T T I I
When not installing the drain pump
Do not give the hose upward gradient after
the connection port.
This will cause water to flow backwards when
the unit is stopped, resulting in water leaks.
Upward gradient
Do not apply force to the piping on the unit side
when connecting the drain hose. The hose should
not be allowed to hang loose from its connection to
the unit. Fasten the hose to a wall, frame or other
support as close to the unit as possible.
12
E-
Care must be taken when installing the drain hose for the indoor unit to
ensure that any condensate water is correctly drained outside.
1 Install the drain hose so that its length can be as short as possible.
Internal diameter of the drain hose should be the same or slightly
bigger than the external diameter.
N N o o t t e e
N N o o t t e e
2 Wrap the drain hose with the insulation drain pipe, the insulation drain as
shown in figure and secure them.
O O N N
O O N N
Ceiling
Support pieces
Ceiling
◆ Give a 10mm slant to the drain hose for proper drainage of
condensate ; refer to page 7.
◆ Secure the drain hose with the cable-tie not to be separated
from the unit.
◆ Never remove the rubber cap located on the drain pump hose
connection port. The drain pump hose connection port is used
only when installing an optional drain pump.
When installing the drain pump
The maximum height of drain pump hose is
75cm or less. If it is raised higher than 75cm,
there can be water leaks.
75cm or less
Ceiling