Using Pre-Ground Coffee; Setting The Timer; Drip Stop Function - Philips HD7762 User Manual

Press in the centre of the knob to confirm,
14
Then press in the centre of the knob again to
start the brewing process (Fig. 19).
•
The grinder grinds the required amount
of coffee beans.
Wait until the coffeemaker has stopped
15
brewing before you remove the jug.
Note:
D
After brewing, coffee drips from the filter
basket for several seconds.

5.3 Using pre-ground coffee

If you want to use pre-ground coffee instead of
coffee beans, follow the steps below.
Open the water reservoir lid and fill the water
1
reservoir with the required amount of cold
water. (Fig. 6)
To open the filter basket holder, pull at its tab
2
on the right side of the coffeemaker (Fig. 14).
Take a paper filter (type 1x4 or no. 4) and
3
fold the sealed edges to prevent tearing and
folding. Place the paper filter in the filter
basket (Fig. 15).
Put pre-ground coffee in the paper filter.
4
Note:
D
You can adjust the strength of the coffee to your
own personal taste. For a medium-strong cup of
coffee, use one measuring spoon (approximately
6g) of ground coffee for each cup (120ml).
For stronger coffee, use 1.5 measuring spoons of
ground coffee for each cup of coffee.
Close the filter basket holder.
5
Put the jug in the appliance (Fig. 7).
6
Press the on/off button (Fig. 8).
7
•
The display lights up.
Press the strength select button (Fig. 9).
8
Turn the knob to choose the pre-ground
9
coffee setting (Fig. 10).
•
The pre-ground coffee icon lights up.
Press in the centre of the knob to confirm.
10
Then press in the centre of the knob again to
start the brewing process (Fig. 11).
8
Wait until the coffeemaker has stopped
11
brewing before you remove the jug.
Note:
D
After brewing, coffee drips from the filter
basket for several seconds.

5.4 Setting the timer

The timer enables you to program the time at
which you want the brewing process to start.
Make sure all steps of brewing coffee are taken
with either preground coffee or coffee beans
before setting the timer.
Press the timer button. (Fig. 20)
1
• On the display 00:00 flashes to indicate
that you have to set the timer.
Turn the knob to set the hour (Fig. 21).
2
Press in the centre of the knob to confirm the
3
hour (Fig. 22).
• The minutes starts to flash to indicate that
you have to set the minutes.
Turn the knob to set the minutes (Fig. 23).
4
Press in the centre of the knob to confirm the
5
minutes (Fig. 24).
•
The timer is set and the brewing process
will start at the preset time.

5.5 Drip stop function

The drip stop function enables you to remove
the jug from the coffeemaker before the brewing
process is finished. When you remove the jug,
the drip stop stops the flow of coffee into the jug.
Note:
D
The brewing process does not stop when you
remove the jug. If you do not put the jug back
into the appliance within 20 seconds, the filter
basket overflows.