How To Install The Seat; How To Assemble The Steering Wheel - Murray 387004x48A Instruction Book

HOW TO INSTALL THE SEAT

Use the fasteners shown below to install the seat. The fasteners are
shown at full size.
(A)
1001054
1. Carefully remove the plastic bag from the seat.
2. Align the holes in the seat hinge to the holes in the seat
(Figure 4). Fasten the seat to the seat hinge with the fasteners
as shown.
4. Slide the tube into the console (Figure 6). Make sure the end
of the tube fits over the steering bushing.

HOW TO ASSEMBLE THE STEERING WHEEL

Fasteners are not required to assemble the steering wheel. Attach
the steering wheel as follows:
1. Make sure the front wheels point forward.
2. Place the bellows in position on the console. (Figure 5)
3. Slide the steering wheel and steering post through the bel-
lows and console. Make sure the end of the steering post
aligns with the pinion gear. Push on the steering wheel. The
steering post will lock onto the pinion gear.
Pull on the steering wheel. Make sure that the steering post
is locked in place.
Bellows
F-040733L
ASSEMBLY
(B)
17x47
Console
Figure 5
3. Check the operating position of the seat. If the seat needs to
be adjusted, loosen the two wing bolts. Slide the seat forward
or backward along the seat adjusting holes as shown. Tighten
the wing bolts (A).
Steering Wheel
Steering Post
Steering Post
Pinion Gear
12
Seat
Seat Hinge
Seat
Adjusting Hole
B
A
Figure 4
Hub
Cover
Figure 6