Warnings - Graco 16N658 Operation - Repair - Parts

Warnings

Warnings
The following warnings are for the setup, use, maintenance, and repair of this equipment. The exclamation point sym-
bol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols
appear in the body of this manual or on warning labels, refer back to these Warnings. Product-specific hazard sym-
bols and warnings not covered in this section may appear throughout the body of this manual where applicable.
GROUNDING
This product must be grounded. In the event of an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric current. This product is equipped with a cord
having a grounding wire with an appropriate grounding plug. The plug must be plugged into an outlet
that is properly installed and grounded in accordance with all local codes and ordinances.
• Improper installation of the grounding plug is able to result in a risk of electric shock.
• When repair or replacement of the cord or plug is required, do not connect the grounding wire to
either flat blade terminal.
• The wire with insulation having an outer surface that is green with or without yellow stripes is the
grounding wire.
• Check with a qualified electrician or serviceman when the grounding instructions are not completely
understood, or when in doubt as to whether the product is properly grounded.
• Do not modify the plug provided; if it does not fit the outlet, have the proper outlet installed by a
qualified electrician.
• This product is for use on a nominal 120 V circuit and has a grounding plug similar to the plug
illustrated in the figure below.
Ground
• Only connect the product to an outlet having the same configuration as the plug.
• Do not use an adapter with this product.
Extension Cords:
• Use only a 3-wire extension cord that has a 3-blade grounding plug and a 3-slot receptacle that
accepts the plug on the product.
• Make sure your extension cord is not damaged. When using an extension cord, be sure to use a
cord heavy enough to carry the current that your sprayer draws. See chart for appropriate sizes and
lengths:
• An undersized extension cord will result in a drop in line voltage and loss of power, overheating, and
possible damage to equipment.
3A2587B
WARNING
WARNING WARNING WARNING
ti4295a
Extension Cord Gauge
(AWG Minimum)
18
16
14
Extension Cord Length
(Maximum)
50 ft (15 m)
100 ft (30 m)
200 ft (61 m)
3