Edacs Operation; Turning On The Radio; Receiving A Call; Individual Call - Ericsson EDACS Monogram Series Operator's Manual

TURNING ON THE RADIO

Rotate the POWER ON-OFF/VOLUME control clockwise, out of
detent, to turn on the radio. A short beep (if enabled through programming)
indicates the radio is ready for operation. The display indicates the last
selected System and Group.
In the EDACS trunked environment, if communications with the
system's control channel cannot be established, the NC message will be
displayed. This may occur if, for example, the radio is out of range of the
trunking site. It may be necessary to move to another location or select
another trunking system to re-establish the control channel link for trunked
mode operations.
The radio will automatically transmit a "log-in" message whenever the
radio is turned on or whenever the radio roams into a new system when
changing the Group selection. This "log-in' message includes the Logical ID
and the Group ID for that radio.

RECEIVING A CALL

1. Turn on the radio as indicated in paragraph TURNING ON THE
RADIO.
Adjust the POWER ON-OFF/VOLUME control clockwise to the
2.
desired audio level.
3. Select the desired System by pressing the
<
the
Systems programmed can be selected.
4. Select the desired Group by pressing the
scroll to the desired Group. Only Groups programmed can be
selected.
5. The radio is now ready to receive calls.

Individual Call

1. If an Individual Call (call directed only to your radio) is received,
the radio unsquelches on the assigned Group. The BUSY status
flag will light.

EDACS OPERATION

>
or ramp button to scroll to the desired System. Only
button and then using
< >
or ramp button to
15