Inserting Batteries Into The Remote - Sony STR-DH770 Manual

23.98/24 Hz
720 × 480p @ 59.94/60
○
Hz
○
720 × 576p @ 50 Hz
640 × 480p @ 59.94/60
○
Hz
*1 If you use YCbCr 4:4:4/YCbCr 4:2:2/RGB 4:4:4 or YCbCr 4:2:0 Deep Color (Deep Colour) (10 bit or 12 bit) of
these video formats, we recommend you to use Premium High Speed HDMI Cables with Ethernet, which can
support bandwidth up to 18 Gbps, and be sure to set the HDMI signal format to [ENHANCED] in the [<HDMI>]
menu. For details, see "Setting HDMI signal format (SIGNAL
If you use Deep Color (Deep Colour) (10 bit or 12 bit) of these video formats, we recommend you to use
*2
Premium High Speed HDMI Cables with Ethernet, which can support bandwidth up to 18 Gbps, and be sure to
set the HDMI signal format to [ENHANCED] in the [<HDMI>] menu. For details, see
(SIGNAL FMT.)."
Note
Depending on the TV or video device, 4K or 3D content may not be displayed. Check the HDMI
video formats supported by the receiver.
Refer to the operating instructions of each connected device for details.
[31] Preparation 5. Turning on the receiver/preparing the remote control
Inserting batteries into the remote control
Insert two R03 (size AAA) batteries (supplied) into the remote control. Make sure that the + and
– ends are in the correct position when installing batteries.
Note
Do not leave the remote control in an extremely hot or humid place.
Do not use a new battery with an old one.
Do not mix manganese batteries with other kinds of batteries.
Do not expose the remote control sensor to direct sunlight or lights. Doing so may cause a
malfunction.
If you do not intend to use the remote control for an extended period of time, remove the batteries to
avoid possible damage from battery leakage and corrosion.
When the receiver no longer responds to the remote control, replace both of the batteries with new
ones.
[32] Preparation 5. Turning on the receiver/preparing the remote control
Turning on the receiver
Before connecting the AC power cord (mains lead), be sure to make connections with speakers
and the other devices.
Connect the AC power cord (mains lead) to a wall outlet.
1
- -
- -
- -
FMT.)."
-
-
-
"Setting HDMI signal format