Table of Contents
Advertisement
Right.side.panel
<Memo>: When you connect an external battery
pack, use a center positive 5 .5 mm outer diameter x
2 .1 mm inner diameter plug and supply 9 V to 24 V
power .
<Caution>: Please ensure that the power is off when
you connect or disconnect a plug .
❺ [PHONES].connector.[3 .5.mm.mini.jack]
Connects stereo headphones .
The connector is a stereo mini jack .
❻ [OUTPUT].connectors.(L.and.R)
These connectors output the stereo mix signal in
the stop or recording mode, while they output the
stereo playback signal in the playback mode .
The connectors are unbalanced RCA jacks and
the nominal output level is -10 dBV .
❼ [RTN.IN].connector.[3 .5.mm.mini.jack]
Connects to the stereo output of an external au-
dio device .
You can monitor the signal received from this
connector using headphones connected to the
[PHONE] connector .
The connector is a stereo mini jack and the nomi-
nal output level is -10 dBV .
❽ [SD-CARD].slot
This SD card slot is located inside the cover (see
"SD card" on page 9) .
To set an SD card to the slot, hold an SD card
with the label side facing to the battery case
compartment and press the card into the slot un-
til you hear a click .
To remove an SD card, firmly press the card into
the slot and release it . The card should pop par-
tially out of the slot . Remove the card from the
slot .
<Memo>: You can use the following SD card types .
SD, SDHC, MiniSD, MiniSDHC,
MicroSD, MicroSDHC
* When you use a MiniSD, MiniSDHC, MicroSD or Mi-
croSDHC card, an SD card adaptor is needed .
* You cannot use an SDXC card .
❾ Battery.case.compartment
To run the unit on battery power, insert the sup-
plied battery case with four AA batteries to this
compartment .
To remove battery case, open the cover and pull
the ribbon attached to the battery case to lift the
case from the compartment .
It is recommended to use alkaline or Ni-MH bat-
teries (see "Preparing the power supply" on page
9) .
Features.and.controls
8
Top.panel
❶
❶ Screw.holes.for.camera.mount.bracket.
These holes are used for fixing the supplied
camera mount bracket . The bracket is used for
mounting a DSLR to the unit (see "Mounting a
DSLR to the unit" on page 26) .
❷ Infrared.transmitter.
Transmits the signal for controlling a DSLR that
can accept infrared remote start/stop signal . A
DSLR can start or stop recording in sync with the
unit (see "Starting/stopping DSLR recording in
sync with the unit" on page 26) .
Bottom.panel
❶ Tripod.screw.holes
Used for mounting the unit on a camera tripod,
etc . Three holes are provided (see "Using a tri-
pod" on page 27) .
❷
❶
Advertisement
Table of Contents
