Table of Contents
Advertisement
3. If the impeller is damaged or broken completely back flush the coolant system to
ensure no solid pieces are in the system.
4. Remove foot brake.
5. Drain engine transmission oil by removing drain screw using a 13mm- hex
wrench. (item 2 in the figure below).
6. Remove kick-starter cover using a 5mm hex key. (item 3 six places)
7. Remove clutch and basket.
8. Unscrew water elbow fitting. (Figure 40)
8. Remove ignition cover using a 4mm hex key (four places)
9. Remove belt retainer screw using a 4mm hex key. (Figure 41 - item 1)
10. Remove belt retainer, water pump belt and water pump fan pulley.
11. Remove bearing retainer screw using a 3mm hex key. (Figure 41 – item 2)
12. Heat engine case around area of impeller lightly with a small Burnsmatic propane
torch. Using a 3/8" diameter x 8" long steel rod, tap impeller assembly out of
engine as shown in figure 42.
CAUTION:
Figure 40
Figure 41
Figure 42
58
Advertisement
Table of Contents
