Pioneer DVR-543H-S Service Manual page 83

5
• Details on HDD data are described below:
QQ
3 7 63 1515 0
HDD
Table 1: HDD recognition status represented by the HDD data display
HDD identification conditions
Failure in physical identification of HDD
(no connection, defective HDD, interface error)
Physical identification of HDD possible, but not identified
(CPRM ID is not input.)
Physical identification of HDD possible, HDD identified,
but failure in logical formatting
Physical identification of HDD possible, HDD identified,
and correct logical formatting (HDD correctly identified)
If an error indication in the HDD data does not disappear even after the above measures were taken, refer to another sheet of "HDD Service
Mode."
(2) Simple diagnosis of the RF level (Subscreen 1)
[Purposes]
TE
L 13942296513
[How to enter]
[How to quit]
[Description]
www
.
5
http://www.xiaoyu163.com
6
: WDC10234564 # 160
If any abnormality exists in HDD connection, the indications shown in Table 1 below are displayed.
To check the RF signal of the U/V tuner by checking the input frequency difference and AGC voltage
in this debug mode
While the User Setting display is displayed, press the ESC , DISP , then DIG/ANA keys, in that order.
Press the ESC key.
DVR-540H/KUC VERSION : 1.∗∗
SYSCON : RELEASE_∗∗∗
Rev :1.∗∗∗∗∗∗
TUNERCON : 198.000
DRIVE : DVD-RW DVR-L11X
1.00
HDD : WDC WD800BB-xxJKCx
DEVICE : E2R-FE FLASH : 64M
C : ∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗
REGION : 1
: ∗∗ ch
Input CH
Freq Diff : Low 1
: ∗∗∗∗ mV
AGC Volt
Subscreen 1
x ao u163
y
i
6
http://www.xiaoyu163.com
7
2 9
8
Capacity of the HDD (unit: Gbytes)
HDD identification error indication
Name of manufacturer, part No. by manufacturer
Example of HDD data
to be displayed
Blank space
WDC 10234564 # 160
WDC 10234564 ! 160
WDC 10234564 160
Q Q
3 6 7 1 3 1 5
OK
OK
OK
80
Input channel
Input frequency difference
AGC voltage
co
.
DVR-640H-S
7
8
9 4 2 8
Remarks
• Check the connection to the ATA connector.
• Replace the ATA flexible cable and connector.
• Replace the HDD.
• Replace the resistor in the ATA communication
line.
• Input the CPRM ID.
"!" represents an HDD-recognition error.
• Initialize the HDD or erase all titles.
0 5 8 2 9 9 4 2 8
m
9 9
A
B
C
9 9
D
E
F
83
8