Checking The Eye-Q Operation; Ping Test; Lan Port Inspection (Ping Test); Magic Motion Remote Controller Test - LG 42PM4700 Service Manual

4.5. Checking the EYE-Q Operation.

(1) Press the EYE Key on the adjustment remote controller.
(2) Check the Sensor DATA ( It must be under 10) and keep
the data longer than 1.5s
Green Eye-Check(Factory Mode)
Sensor Data
Power saving mode
(3) Check 'OK'
(Sensor DATA 0 ~ 4095, Power Saving Mode 0 ~ 12)
* IF you press IN-STAP Button, change Green Eye-check
OSD.

4.6. PING TEST

* In this case Network setting is on Manual Setting.
Connect : SET->LAN Port == PC->LAN Port
4.6.1. Equipment Setting
(1) Play the LAN Port Test PROGRAM.
(2) Input IP set up for an inspection to Test
* IP Number : 12.12.2.2

4.6.2. LAN PORT inspection (PING TEST)

* In this case Network setting is on Manual Setting.
(1) Play the LAN Port Test Program.
(2) connect each other LAN Port Jack.
(3) Play Test (F9) button and confirm OK Message.
(4) remove LAN CABLE
Copyright © LG Electronics. Inc. All rights reserved.
Only for training and service purposes
9
1
OK
- 9 -

4.7. Magic Motion Remote Controller test

(1) Equipment: RF R/C for test,
(2) You must confirm the battery power of RF-R/C before test
(Recommend that change the battery per every lot)
(3) Sequence (test)
1) if you select the 'start key(Wheel Key)' on the controller,
you can pairing with the TV SET.
2) You can check the cursor on the TV Screen, when select
the 'Wheel Key' on the controller
3) You must remove the pairing with the TV Set by select
'Mute Key' on the controller.
4.8. 3D function test
- Required Equipment
● Pattern Generator :
MSHG-600, MSPG-6100 [SUPPORT HDMI1.4])
MODE : HDMI mode NO. 872
Pattern No.83
(1) Please input 3D test pattern like below (HDMI mode NO.
872 , pattern No.83)
(2) When 3D OSD appear automatically, then press OK button
on ADJ Remote Controller.
(3) Check the picture. The picture must be same as below.
(Don't have to wear 3D glasses.)
LGE Internal Use Only