Operation As Screwdriver; Setting Initial Starting Point; Operating In Forward/Reverse Direction; Variable Speed - DeWalt DCF682 Instruction Manual

Vdrl_tLIOr] r.Pdsec! or] [oroc!UCL corn[oor]er]LS, Lsrn[o_r_tLur8 _tr]c! _no-user
application.
For more information regarding the battery fuel gauge, please call
1-800-4-DEWALT (1-800-433-9258) or visit our website www.dewalt.
com.
To Operate
Your screwdriver uses gyroscopic technology to sense your hand
motion. To operate, press in the motion control activation trigger
and turn your hand in the direction that you want the screwdriver to
operate.
SETTING INITIAL STARTING POINT
1. Grasp the screwdriver as shown in Figure 6.
2. Press and hold in the motion control activation trigger.
3. When the LED illuminates the tool is ready for use.
4. To reset initial starting point first release the motion control
activation trigger. Move tool to new position, then press and hold
in the motion control activation trigger.
OPERATING IN FORWARD DIRECTION
1. Grasp the screwdriver as shown in Figure 6.
2. Engage head of fastener with screwdriver accessory on work
piece. Follow instructions for setting initial starting point.
3. Rotate your hand to the right and the screwdriver will activate in
the forward direction.
OPERATING IN REVERSE DIRECTION
1. Grasp the screwdriver as shown in Figure 6.
IO turn 1:he 1:OOl oH, release 1:he tool:ion control ac1:lva1:lon 1:rigger.
VARIABLE SPEED
• The spindle speed is dependent upon the speed that you rotate
your hand.
• The slower you rotate your hand, the slower the screwdriver turns.
The faster you rotate your hand, the faster the screwdriver turns.
If you wish to increase the spindle speed, rotate your hand further
in the same direction.
If you wish to decrease the spindle speed, rotate your hand back
towards the initial starting point.
FIG. 6
Operation as a Screwdriver
DCF680, DCF682
Insert the appropriate hex shank bit into the chuck (H). Refer to To
Operate for instructions. To determine the proper position of the
torque adjustment collar (DCF680 only) make a few practice runs in
scrap or unseen areas.
11