C. Installing the Optional Electric Kit
•
Remove four screws to remove cover from the control
box.
Figure 6.3
Remove Control Cover
•
Remove the junction box bracket by prying loose with a
screwdriver. Remove the two screws shown in Figure 6.4.
Cut out and remove insulation from behind junction box
bracket, Figure 6.5.
Remove
2 screws
Junction
Box Bracket
Figure 6.4
Remove Junction Box Bracket & Two Screws
Figure 6.5
Cut and Remove Insulation
14
Outdoor Lifestyles by Hearth & Home Technologies Inc. • Carolina • 4066-300 • Rev. E • 9/09
•
Make hand bends to bracket as shown below:
Figure 6.6
Hand-bend Bracket
•
Fasten bracket to junction box with two screws (provided
with junction box).
Figure 6.7
Fasten Bracket to Junction Box
•
Thread wire into junction box.
•
Place junction box into the control box, matching holes
as shown, and fasten with the two screws removed in
Figure 6.4.
Figure 6.8
Place & Fasten Junction Box
Match holes