Advertisement
3.1.23 PROJECTION UNIT
• Take out the SPEAKER GRILLE.
• Take out the FRONT CONTROL BOX.
• Take out the REAR PANEL.
• Take out the MAIN UNIT.
(1) Take out the CRT SOCKET PWB.
(2) Remove 4 screws [A].
(3) Pull out the PROJECTION UNIT upward.
NOTE :
• Refer to "PROJECTION UNIT REPLACEMENT" on page 1-
9 when taking out and replacing the PROJECTION UNIT.
• When wire clamps are removed during work, use care to
restore
them
precisely
Performance can be affected if these are not returned to the
original positions.
3.1.24 HV DIVIDER
• Take out the REAR PANEL.
(1) Remove 1 screw [B].
(2) Take out the HV DIVIDER.
*Wires of the transformer (FBT) and CRT of each
PROJECTION UNIT can be removed by turning the
connector portions.
NOTE :
• If necessary, remove the anode wires, and replacing the HV
DIVIDER, take care to correctly engage the connector.
3.1.25 REMOTE SENSOR PWB
• Take out the REAR PANEL.
(1) Disconnect the connector [R].
(2) Remove 1 screw [C].
(3) Take out the REMOTE SENSOR PWB.
to
their
original
positions.
A
(x4)
FRONT
REMOTE
SENSOR PWB
R
C
Pull
(x1)
SENSOR PWB
Turn
CONNECTOR
B
(x1)
Fig.10
PROJECTION UNIT
REMOTE
HV
DIVIDER
(No.YA173)1-15
Advertisement
