Pulley/Motor/Damper - LG WD-10151SUP Service Manual

PULLEY, MOTOR, DAMPER
Clean the drain pump filter
0 1 0
Open the lower cover cap (①) by
using a coin. Turn the drain plug
(②) to pull out the hose.
(PULLEY)
(MOTOR)
(DAMPER)
2
1
Unplug the drain plug (②), then
the water flows out,
At this time use a vessel
to prevent water flowing on the
floor. If the water does not flow any
more,turn the pump filter (③) open
to the left.
① Remove the back cover.
② Take off the belt turning the pulley.
③ Unscrew the bolt to pull out the pulley.
① Unscrew 2 screws from the bracket.
② Push the motor in the arrow direction for
disassembling.
③ When reassembling the motor, make sure that motor
mounting bushings are not taken off from the bracket.
① Pull out the hinge, pressing its snap.
② Do not use the pulled out hinge again. It may be taken
off during operation.
3
28
2
Take out any foreign material
from the pump filter (③). After
cleaning, turn the pump filter(③)
clockwise and insert the
drain plug (②)to the original
place. close the lower cover cap.
3