Deflection York Tilt Adjustment; 2-Pole Magnet Adjustment (Green, Red); 4-Pole Magnet Adjustment; Defocus Adjustment (Blue) - Sony KP-53XBR300 Service Manual

3-5. DEFLECTION YOKE TILT ADJUSTMENT
1. Receive the Monoscope signal.
2. Set in service mode.
3. Set MCP1 07 GON to "001" 08 RON to "000" and 09 BON to
"000" to show only the green color.
4. Loosen the deflection yoke set screw and align the tilt of the
Deflection Yoke so that the bars at the center of the
monoscope pattern are horizontal.
5. After aligning the deflection yoke, fasten it securely to the
funnel-shaped portion (neck) of the CRT.
6. The tilt of the deflection yoke for red is aligned in the mode
MCP1 07 RON "001", 08 GON "000", 09 BON "000" on the
service mode menu, and the tilt of the deflection yoke for blue
is aligned with in the mode MCP1 07 RON "000", 08 GON
"000", 09 BON "001" on the service menu, is aligned the
same as was done for green.
Note: Instead of item 3, you can use the lens caps to cut off the
unnecessary color beams.
4-pole magnet
Deflection yoke
2-pole magnet
Fig. 3-6
3-6. 2-POLE MAGNET ADJUSTMENT
(GREEN,RED)
1. Receive the Dot signal.
2. Set in service mode.
3. Set MCP1 07 GON to "001" 08 RON to "000" and 09 BON to
"000" to show only the green color.
4. Turn the green VR on the focus block to the right and set to
overfocus to enlarge the spot.
5. Now align the 2-Pole Magnet so that the enlarged spot is in the
center of the Just Focus spot.
6. Align the green focus VR and set for just (precise) focus.
7. Perform the same alignment for red.
Use the center dot
Anode cap
Fig. 3-7

3-7. 4-POLE MAGNET ADJUSTMENT

1. Receive the Dot signal.
2. Set in service mode.
3. Set MCP1 07 GON to "001" 08 RON to "000" and 09 BON to
"000" to show only the green color.
4. Turn the green VR on the focus block to the left and set to
underfocus to enlarge the spot.
5. Now align the 4-Pole Magnet so that the enlarged spot
becomes a perfect circle for green and red.
6. Perform the same alignment for blue.
Use the center dot

3-8. DEFOCUS ADJUSTMENT (BLUE)

1. Select the video menu and set the mode to "VIVID" mode.
2. Set to the service mode.
3. Change TV mode to the video input mode.
4. Set to PJE, and press 6 to display the test signal (dots) on the
screen.
5. Turn the blue VR on the focus block to adjust to the diameter
of the dots as shown in the figure below.
[Focus adjustment point]
Inch
L
– 43 –
KP-53XBR300/61XBR300
RM-Y902
x
/
y
x : y = 1:1.5 (BIue)
x : y = 1:1 (Green, Red)
Fig. 3-8
Lmm Max
53" 61"
8 9
Fig. 3-9
RM-Y902