Garden Fresh Tm Crisper; Chiller Fresh Tm System (Some Models) - Amana BCI21WW Owner's Manual

TM
Garden Fresh Crispers
TM
Garden Fresh crispers keep produce fresh longer. Wrap
produce tightly. Do not wash produce before placing in
crispers. Excess moisture could cause produce to spoil
prematurely. Do not line crispers with paper towels. Paper
towels retain moisture.
Garden Fresh TM crispers control is located below front
shelf trim. Control adjusts humidity in crisper drawers.
Slide control to high for produce with leaves such as
lettuce, spinach or cabbage. Slide control to low for
produce with skins such as cauliflower, corn or tomatoes.
Remove shelf and crisper drawers by completing the
following steps:
1. Open left crisper.
• For doors hinged on left, open right crisper.
!
CAUTION:
Handle tempered glass shelves carefully to avoid
personal injury or property damage. Shelves may break
suddenly if nicked, scratched, or exposed to sudden
temperature change.
2. Remove glass crisper top by gently pushing up from
underneath. Tilt one end up and pull out.
3. Remove left crisper by lifting from front while
supporting underneath and pulling out. For doors
hinged on left, remove right crisper.
4. Remove support post at recess in bottom center of
Fresh Food section.
5. Remove other crisper by sliding to opposite wall. Lift
from front while supporting underneath and pull out.
6. Replace crispers and shelf by performing steps 2–5
in reverse order.
TM
Chiller Fresh System
(some models)
The Chiller Fresh TM System features a drawer inside a
sleeve. Freezer air circulates between drawer and
sleeve. This systems keeps food fresh longer and up to
5°F (3°C) colder than refrigerator temperature.
Chiller Fresh
Control adjusts amount of air circulating around drawer.
Slide control to COLD for normal refrigerator temperature
and to COLDER for colder temperature. Ice crystals may
form on drawer or food on COLDER setting. Cold air
entering the Chiller Fresh
refrigerator temperature. Fresh Food control may need to
be adjusted to a lower number to compensate for colder
air.
Chiller Fresh
right side of the refrigerator compartment to accomodate
different storage needs. To move drawer perform the
following steps:
1. Remove drawer by lifting and pulling out. Remove
shelf by lifting from front, releasing hooks from metal
track, then pulling out.
2. Remove plastic cap from back wall of Fresh Food
section by placing a knife covered with masking tape
underneath cap and pulling forward.
3. Rotate boot 180° to opposite side.
4. Insert plastic cap in opposite side of Fresh Food
section. Confirm cap is snugly in place. Cold air
may cause food to freeze if cap is not replaced.
5. Replace shelf by inserting hooks into metal track and
lowering the front. Use slots 4 though 6 only.
6. Replace drawer by sliding in. Make sure boot fits
Glass crisper
snugly over air inlet in back wall.
top
Chiller Fresh System
installed on left side of
refrigerator
Chiller Fresh
control
Chiller Fresh System
installed on right side of
refrigerator
Chiller Fresh
control
9
TM control is located below front shelf trim.
TM
drawer can decrease
TM
drawer can be moved from the left to the
Boot
Plastic
cap
Air
inlet
Plastic
cap
Metal
track
Air
inlet
Boot
rotated
180°