Advertisement
Available languages
Available languages
• Using t heretracting lever, retract lower blade guard t oanupward position. Lower rear o f
shoe u ntil blade t eeth almost touch cutting l ine.
• Release theblade g uard ( its contact with the work will k eep itinposition toopen freely a s
you start t he cut). R emove hand from guard l ever a nd firmly grip secondary handle (4), a s
shown i nfigure N.Position your b ody a nd arm toallow you toresist kickback ifitoccurs.
• Make sure blade isnotincontact with cutting s urface b efore s tarting saw.
• Start t hemotor, allow saw tocome tofullspeed, and then gradually lower thesaw until
itsshoe rests f latonthematerial tobecut. A dvance saw along the cutting l ine until cutis
completed
asshown i nfigure N.
• Release trigger andallow blade tostop completely before w ithdrawing
theblade from
thematerial.
• When starting e ach new cut,repeat asabove.
TROUBLESHOOTING
Problem
Possible Cause
• Unitwill not start.
• Battery pack not installed properly.
• Battery pack not charged.
• Battery pack will not charge. • Battery pack not inserted into charger.
• Charger not plugged in.
• Surrounding air temperature
too hot or too cold.
Possible Solution
• Check battery pack
installation.
• Check battery pack
charging requirements.
• Insert battery pack into
charger until LED
appears.
• Plug charger into a
working outlet. Refer to
"Important Charging Notes"
for more details.
• Move charger and battery
pack to a surrounding air
temperature of above 40
degrees F (4,5°C)or below
105degrees F (+40,5°C).
SPECIAL NOTES FOR USE WITH LITHIUM BATTERIES
• Unit shuts off abruptly.
• Battery pack has reached its
maximum thermal limit.
• Out of charge. ( To
maximize the life of the
battery pack it is designed
to shutoff abruptly when
the charge is depleted.)
For assistance with your product, visit our website www.blackanddecker.com
for the location
of the service center nearest you or call the BLACK+DECKER
help line at 1=800=544=6986.
•Allow battery pack to cool
down.
• Place on charger and
allow to charge.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
IMPORTANT:
To assure product SAFETY and RELIABILITY,
repairs, maintenance and
adjustment (other than those listed in this manual) should be performed
by authorized
service centers or other qualified service personnel, always using identical replacement parts.
ACCESSORIES
Recommended
accessories for use with your tool are available from your local dealer or
authorized service center. If you need assistance regarding accessories, please call:
1=800-544-6986.
Z_WARNING:
The use of any accessory not recommended for use with this tool
could be hazardous.
RBRC SEAL
TM
O
The RBRC
TM
(Rechargeable
Battery Recycling Corporation) Seal on the lithium-
ion battery (or battery pack) indicates that the costs to recycle the battery (or
battery pack) at the end of its useful life have already been paid by BLACK+DECKER.
In
some areas, it is illegal to place spent lithium-ion batteries in the trash or municipal solid
waste stream and the RBRC program provides an environmentally
conscious alternative.
RBRC in cooperation with BLACK+DECKER and other battery users, has established programs
14
Advertisement
