Table of Contents
Advertisement
LATIN AMERICA: This warranty does not
apply to products sold in Latin America.
For products sold in Latin America, check
country specific warranty information
contained in the packaging, call the local
company or see the website for warranty
information.
SAW OPERATION
Problem
Possible Cause
• Blade hits
• Misalignment.
table.
• Angle of cut
• Miter table unlocked.
not accurate.
Can not adjust
• Sawdust under table.
miter.
• Cutting arm
• Loose pivot points.
wobbles.
• Cutting arm
• Pivot spring not replaced
will not fully
raise, or blade
• Sawdust build-up.
guard won't
fully close.
• Blade binds,
• Improper operation.
jams, burns
wood.
• Dull or warped blade.
• Improper blade size.
•
• Saw vibrates
• Saw blade not round / damaged
or shakes.
• Arbor bolt loose.
TROUBLESHOOTING
properly after service.
Wood is moving during cut.
/ loose.
Possible Solution
• See ADJUSTMENT -Setting
Cutting Depth section.
• See OPERATION - Miter Angle
Adjustment section.
• Vacuum or blow out dust. WEAR
EYE PROTECTION.
• Contact Service Center.
• Clean and lubricate moving parts.
• Contact Service Center.
• See BASIC SAW OPERATION
section.
• Replace or sharpen blade.
• Replace with 7-1/4 in. diameter
blade.
• Use hold-down clamp to secure
workpiece to table.
• Replace blade.
• Tighten arbor bolt.
30
Advertisement
Table of Contents
