Additional Information; Precautions; Troubleshooting - Sony SA-SPC5 Operating Instructions Manual

Active monitor speaker system
Table of Contents

Advertisement

Precautions

On safety
• Before operating the system, be sure that the operating
voltage of your system is identical with that of your local
power supply.
• Unplug the left speaker from the wall outlet if it is not to
be used for an extended period of time. To disconnect the
cord, pull the cord by grasping the plug. Never pull the
cord itself.
• Should any liquid or solid object fall into the system,
unplug the system and have the system checked by
qualified personnel before operating it any further.
• AC power cord must be changed only at the qualified
service shop.
When turning on or off an amplifier or other equipment
Lower the volume of the amplifier to minimum.
To avoid damaging the system
• Be careful in setting the volume control of the left speaker
and woofer to avoid an excessive input power.
• Do not attempt to open the enclosuer or remold speaker
units and amplifier.
In case color irregularity is observed on the nearby TV
screen
With the magnetically shielded type of the speaker system,
the speakers can be installed near a TV set. However, color
irregularity may still be observed on the TV screen
depending on the type of your TV set.
If color irregularity is observed...
nTurn off the TV set once, then turn it on after 15 to 30
minutes.
If color irregularity is observed again...
nPlace the speakers further apart from the TV set.
On cleaning the cabinet
Clean the cabinet with a soft cloth lightly moistened with
water. Do not use any type of abrasive pad, scouring
powder or solvent such as alcohol or benzine.
If you have any questions or problems concerning your
system that is not covered in this manual, please
consult your nearest Sony dealer.

Additional Information

Additional Information

Troubleshooting

If you experience any of the following difficulties while
using the system, use this troubleshooting guide to
help you remedy the problem. Should any problem
persist, consult your nearest Sony dealer.
There's no sound.
/ Check that this system and components are
connected correctly and securely.
/ Rotate LEVEL clockwise to turn the volume up.
The sound has suddenly stopped.
/ The speaker cords may have short-circuited.
Connect the cords properly.
The sound is distorted.
/ The input signal is imperfect.
/ The input signal level is too high.
Severe hum or noise is heard.
/ The contacts between the plugs of the
connecting cords and the corresponding jacks
have not been made properly. Connect the
plugs firmly.
/ The audio system is picking up some noise
from a TV set. Move the audio system away
from the TV set or turn the TV set off.
7

Advertisement

Table of Contents
loading

Table of Contents