Installation Instructions - HP procurve radio port 220 Installation And Getting Started Manual

4. After this sequence, assuming no error conditions have occurred, the
Radio Port will enter Normal operation mode. This means that the Radio
Port has successfully communicated with and been adopted by a wireless
services-enabled switch. If this startup sequence repeats itself, then it is
likely that the Radio Port is unable to contact a compatible wireless
services -enabled switch, and the installer should review the Trouble-
shooting section below.
Normal Operation:
Once the Radio Port has established a connection to a compatible wireless
services-enabled switch the Radio Port will begin normal operation. During
normal operation, the GREEN LED indicates status of the 802.11 b/g radio,
and the AMBER LED indicates status of the 802.11a radio.
Without Wireless Traffic: Each LED will briefly flash once every 5 seconds,
to indicate that power is on, and the Radio Port is communicating nor-
mally to its wireless services-enabled switch. The flashing may not be
synchronous between the two LED indicators.
With Wireless Traffic: Each LED will briefly flash more frequently than
once every 5 seconds, and in an irregular fashion, to represent traffic on
that radio.
Radio Error Mode:
The GREEN LED flashes on and off steadily once per second if an error
prevents the 802.11b/g radio from operating normally.
The AMBER LED flashes on and off steadily once per second if an error
prevents the 802.11a radio from operating normally.

Installation Instructions

The ProCurve Radio Port 220 can be mounted either on a wall or other
mounting point, or above a suspended ceiling. This Radio Port is not designed
for mounting on a desk.
To prepare for installation, perform the following steps:
1. Review site survey and network analysis reports to determine the location
and mounting position for the ProCurve Radio Port 220. Verify the
recommended external antenna type and antenna mounting configura-
tion.
2. Match the Radio Port model number on the purchase order with the model
numbers in the packing list and on the case of the device shipped.
Installation Instructions
9