Installing The Side Brushes - Caiman RVC 40540 Operating Instructions Manual

Fax +1 305 430 9692
When the battery's lifetime is over and it does not charge up
•
anymore, please order a genuine battery pack replacement
from the manufacturer's authorized service center.

INSTALLING THE SIDE BRUSHES

Simply insert the "L" marked side brush on the pin near the L letter on
the base, and the "R" marked side brush on the pin near the R letter.
Push to put in place. To remove the side brushes, simply pull them
out.
INSTALLING A MOP CLOTH
On a flat surface, with a flat screwdriver or the tip of your fingers,
•
insert the 4 corners of the mop cloth into the clamps at the back
of the dusting cloth holder (FIG 5.)
Replace the board on the unit by inserting the holder's tabs in the
•
holes between the side wheels. To remove it, lift up the dust cloth
holder gently.
Note: Before operating the product, if there is no dusting cloth on
the holder, please remove the dusting cloth holder from the main
body.
Copies of the I/B. Please reproduce them without any
changes except under
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
L
8
Assembly page 8/32
special instruction from
Print only
R
FIG. 4
RVC 40540 - 120501
Team