LED Light Indication
When troubleshooting, always observe the color of the LED.
LED Indication
Steady Green
Steady Red
Single Flash Green
Slow Flash Green
Battery temperature is either too hot or too cold
Slow Flash Amber
28
English
Table 4.3: Charger Status
Charger State
Charged at least 95%
Rapid charge
Charged successfully powered up and is ready
for use
Nearly charged at least 90%
Battery under voltage recovery
OR
– Wait to charge
If battery temperature is within operating
temperature, there may be a fault connection
– Do not charge battery
Table 4.3: Charger Status (Continued)
Battery under voltage recovery time out
Fast Flash Red
Excessive power supply voltage
If battery is inserted into a successfully powered
up charger, battery may have bad contact with
Off
Troubleshooting
If There is Fast Flash Red Indication:
1
Confirm the battery being used with the WRSM is listed in Table 1.1
and is good in condition.
2
Confirm that the power supply being used with the WRSM is listed
in Table 1.2 and is good in condition.
3
Remove the battery and restart the Dual-Unit Charger.
4
If the symptom persist, please send the Dual-Unit Charger to the
nearest Service Center for further verification.
OR
Loss of charge current control
OR
OR
Fault connection happened
– Do not charge battery
charger