Install The Hood - K-Star K1012 Operating Instructions Manual

INSTALL THE HOOD

Note: at least two people will be required to mount
the hood.
1. Raise the hood into its mounting position.
2. Align the rectangular
with the wall-mounting bracket. Gently lower the hood
until it securely engages the bracket.
Open the Al. filter and find the two φ8 mm holes
3.
on the back of the hood. Level the hood with 2
mounting screws (4*35mm) with washer. Use drywall
anchors provided.
4. Measure the height of the glass to the slidery duct
fixing support. Adjust the height of the chimney
according to the height. Then use the duct fixing
suppor with two screws (4x8mm) to fix the chimn
Shown as in the pic.
5. Put the ch imney on the hood, use two screws(4x8mm)to
fix the chimney to the slidery duct fixing support.
6. Use the other two screws (4x8mm) to fix the bottom of
chimney.
7. After adjusting the position, open the filter and fix the
body inside with safety screws.
N ote: The two safety vents are positioned on the back
casing, with diameter of 6mm.
opening on the back of the hood
eys.
4x8mm
Screw