C
C
C = Felling notch determines the
direction of fall
:
Make the horizontal cut – check the
direction of fall with the gunning
sight.
:
Make top cut at an angle of about
45°.
:
Check the felling notch and correct it
if necessary.
Important points:
–
Felling notch at a right angle to
planned direction of fall.
–
As close as possible to the ground.
–
Cut to a depth of about
the trunk diameter.
MS 380
Sapwood cuts
Sapwood cuts help prevent long-fibered
wood splintering when the tree falls.
Apply the cuts at both sides of the trunk
at the same height as the bottom of the
felling notch, to a depth of about
the trunk diameter. On large diameter
trees, cut to no more than the width of
the guide bar.
Do not use sapwood cuts on diseased
trees.
1
1
/
to
/
of
5
3
Felling cut
Shout a warning before starting the
felling cut.
–
Make the felling cut (D) slightly
higher than bottom of felling notch.
1
/
of
10
–
Cut horizontally.
–
Leave approx.
uncut. This is the hinge.
English
D
D
1
/
of tree diameter
10
13