Installing The Blade - Roland XC-540 Setup Manual

7. Installing the Blade

CAUTION
CAUTION
1.
Insert a blade into the blade holder.
Insert the pin.
Insert the pin to the position where its end sticks
out about 3 to 5 millimeters.
Blade holder
2.
Enter the blade replacement mode.

MENU
SUB MENU
v
SUB MENU
MAINTENANCE
w
MAINTENANCE
REPLACE KNIFE
x
NOW PROCESSING..
OPEN FRONT
COVER
y
FINISHED?
Be sure to perform operations as specified by these instructions, and
never touch any area not specified in the instructions.
Sudden movement of the machine may cause injury.
Never touch the tip of the blade with your fingers.
Doing so may result in injury, and the cutting performance of the blade will be
impaired.
Pin
Cap
Press
Press
Press
Press
Press
Press
Press
The cutting carriage moves to a location permitting blade replace-
ment, and then the screen shown in the figure appears.
Open the front cover.
Preparations are complete, when this screen appears.
Insert the blade.
Blade
Insert the blade.
.
several times.
.
.
.
twice.
.
45