Opening The Tv Set - Loewe Spheros R 32 HD+ 100 Service Manual

Opening the TV set

Pull out the mains plug!
Remove the connecting cables from the TV set.
Loosen and remove the screws marked with arrows in the corresponding illustration according to the TV model.
Screws for be loosened in the following TV sets:
Spheros R 32 8 screws of size T20, fig. 2
Spheros R 37
The rear panel can be moved carefully rearwards once the screws have been removed.
(Proceed in reverse order to insert the rear panel.)
Attention: the removal of th frontglass can be done only by dealer or tecnicians.
The upper screws of the rear panel (arrow A) are located under a small cover.
The small cover is opened by lifting upwards.
Disassembly of the front screen: see Spheros R 37.
21 screws must be removed to take off the rear panel.
11 screws of size T20 on the rear panel of the TV set fig. 3.
The upper screws of the rear panel (arrow A) are located under a small cover.
The small cover is opened by lifting upwards.
The three screws marked there by an arrow A should be the last of the 21
screws to be removed. The rear panel could otherwise fall backwards
uncontrollably. There are another 10 screws behind the front screen.
To remove the front screen, see fig. 11 to fig. 14.
Procedure:
- Press the front screen forward about 20 mm at the bottom, fig. 11;
- Unhooking the front screen, fig. 12 and 13.
- Observe the rules for handling MOS components, remove plug
(operating eye on the front screen, fig. 14, arrow).
- Put down the screen in a safe place, pull out the baffle in the direction of
the arrow (fig. 15, arrows).
9