Table of Contents
Advertisement
WARNING: Do not attempt to change the
auger belt without the help of an assistant.
It is very important that one person,
standing at the operating position, firmly
hold the snow thrower housing to prevent
it from tipping while the other person
replaces the belt. Failure to comply with
this may result in injury.
Figure 16
•
Standing in the operating position, lift up on the
handles and pull the frame assembly rearward. The
frame and the housing will separate, and the rear
auger belt will come off the pulley. Maintain control
of the frame assembly while pulling it.
•
Remove the two belts from the two engine pulleys.
For location of the belts, see Figure 17.
Remove belt
from pulley
Figure 17
•
To remove the front auger drive belt, push the idler
pulley to the left. The belt brake should move
outward. See Figure 18. Lift the front auger drive
belt from the front auger pulley.
•
Place new belts on the two auger pulleys making
Hex Nut
and
sure that the front auger belt is under the belt brake.
Lock
Route belts under and to the left of the flat idler
Washer
pulley. Hold the belts upward in this position.
•
While lifting up on the handles, bring the frame
assembly close to the auger housing, and place the
two belts on the front and rear engine pulleys. See
Figure 19.
PUSH
Remove belt
from pulley
•
Level the frame assembly and tip the auger
housing forward to align studs with the
corresponding holes on both sides of the frame
assembly.
NOTE: Use care to avoid pinching the control cable.
•
From the frame assembly side, insert six lock
washers and hex nuts on to the studs . Refer to
Figure 16. These pieces of hardware were removed
earlier. Tighten nuts securely.
16
Push auger
idler pulley
Figure 18
Frame
Assembly
Figure 19
WARNING: Push the frame assembly fully
on to the studs.
PUSH
Auger
Housing
Hide quick links:
Advertisement
Table of Contents
