Lighting Instructions - Napoleon BIP500RB Instruction Manual

Lighting Instructions

Burner
WARNING!
Open lid
WARNING!
Ensure all burner controls are in the off position. Slowly turn on the gas
supply valve.
Main Burner
Lighting
1. Open grill lid
2. Push and turn any main burner
knob slowly to the high position. If
the pilot lights, continue to push down
on the control knob until the burner
lights and then release.
3. If the pilot does not ignite, then
immediately turn the control knob
back to the 'off position and repeat
step 2 several times.
4. If the pilot and burner will not
ignite within 5 seconds, turn the
control knob to the 'off' position and
wait 5 minutes for any excess gas to
dissipate. Either repeat steps 2 and 3
or light with a match.
5. If lighting the unit with a match, clip
the match into the supplied lighting
rod. Hold the lit match down through
the grill and sear plate while turning
the corresponding burner valve to
high.
WARNING!
The propane cylinder is equipped with an excess flow device. Unless all burners are
turned off prior to turning the cylinder on, only small flames and low heat will be achievable.
WARNING!
Do not use rear burner while operating main burner.
Rear
Left Left Centre Right Centre
Burner
Burner
Burner
Rear Burner Lighting
(if equipped)
1. Open grill lid
2. Remove warming rack.
3. Turn rear burner control to high
position.
4. Press and hold
igniter button until burner lights,
or light by match.
5. If ignition is not immediate,
turn burner control off. Wait 5
minutes. Repeat.
Right
Burner
Off Position
Side Burner Lighting
(optional)
1. Open burner cover.
2. Turn side burner control to high
position.
3. Press and hold
igniter button until burner lights,
or light by match.
4. If ignition is not
immediate, turn burner control
off. Wait 5 minutes. Repeat.
www.napoleongrills.com
7
EN