Before Initial Use; Operating The Vehicle - Cushman 622015 Owner's Manual

Table of Contents

Advertisement

OPERATING PROCEDURES
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.

BEFORE INITIAL USE

Read and follow the safety label on the instrument panel. Be sure you understand how to operate the vehicle and its
equipment as well as how to use it safely. Maintaining good performance depends to a large extent on the operator.
Before a new vehicle is put into operation, the items shown in the INITIAL SERVICE CHART must be performed.
Vehicle battery must be fully charged before initial use.
Check for correct tire inflation. See GENERAL SPECIFICATIONS.
Check for oil or fuel leaks that could have developed in shipment from the factory.
4
Determine and record braking distance required to stop vehicle for future brake performance tests.
Remove the protective clear plastic, that protect the seat bottom and back rest during shipping, before placing the
vehicle in service.

OPERATING THE VEHICLE

Improper use of the vehicle or the lack of proper maintenance may result in damage or decreased performance.
Read and understand the following warnings before attempting to operate the vehicle.
To reduce the possibility of severe injury or death resulting from loss of vehicle control, the fol-
lowing warnings must be observed:
When driving vehicle, consider the terrain, traffic conditions and the environmental factors which
effect the terrain and the ability to control the vehicle.
Use extra care and reduced speed when driving on poor surfaces, such as loose dirt, wet grass,
gravel, etc.
Stay in designated areas and avoid extremely rough terrain.
Maintain a safe speed when driving down hill. Use service brake to control speed when traveling
down an incline. A sudden stop or change of direction may result in loss of control.
Slow down before and during turns. All turns should be made at reduced speed.
Never drive vehicle up, down, or across an incline that exceeds 14° (25% grade).
4 - 4
ITEM
SERVICE OPERATION
Battery
Charge battery
Seats
Remove protective plastic covering
Brakes
Check operation and adjust if necessary
Check hydraulic brake fluid level if
equipped
Establish mechanical brake base line
Tires
Check pressure (see SPECIFICATIONS)
Fuel
Fill tank with correct fuel
Engine
Check oil level
Initial Service Chart

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Shuttle 2Shuttle 4Shuttle 6

Table of Contents