Switching Off; Turning Off The Power Via Windows 95/98 - Fujitsu Deskpower 5000 Series User Manual

This section explains how to turn off the PC.
Point
- Before turning off the power, terminate all jobs and save all necessary data.
- Before turning off the power, confirm that the access indicator lamps (
1, "Name and Function of Each Component") of the floppy and hard disk drives are off. If
the power is turned off while the access indicator lamps are on, data may be lost or data
in the floppy disk or hard disk may be destroyed.
- If the power cord is unplugged from the outlet or the power is disconnected due to a
power failure while the PC is on, re-connect he power cord or wait until AC power
recovers. When the power recovers, the PC is automatically turned on and started.
"Press <F2> to enter SETUP" may be displayed at this time. In this case, press the [F2]
key, check the Setup items from the menu, and restart the PC.
- If the "Power switch" of the BIOS setup is set to "Standby," pressing the power switch
does not switch off the PC. (
"BIOS Setup").
- Do not turn off the PC while the POST is operating. To switch off the PC while the POST
is operating, press the power switch for at least four seconds and confirm that the power
lamp goes off.
- If the power is turned off during the POST operation due to a power failure or some other
reason, the message, [Press <F1> to resume, <F2> to setup], may be displayed at
rebooting. In this case, press [F2] key, confirm the setup menu, and then reboot.
- If the power lamp is on in orange, repress the power switch for at least four seconds.

Turning off the power via Windows 95/98

○ ○ ○ ○ ○ ○ ○ ○
1
Click [Start].
The "Start" menu appears.
For Windows 95
10

Switching off

see Section 5, "Power-Saving Menu," in Chapter 4,
For Windows 98
see Appendix