Cub Cadet 930 SWE Operator's Manual page 8

Chute Assembly
1. Loosen, but do not remove, the chute crank bracket in
order to attached the chute assembly. See Fig. 3-4.
2. Remove lock nuts and screws securing one of the flange
keepers to the chute assembly. Loosen the fasteners of the
other two flange keepers. See Figure 3-4.
3. Place chute assembly onto chute base as shown in Figure
3-3. Make sure that the chute notches engage with the
spiral end of chute directional control, and the two flange
keepers are beneath the flange on the chute base.
8 s 3— a
ectiOn sseMbly
Figure 3-3
& s -u
et p
4. Secure flange keeper removed earlier with lock nuts and
screws. Tighten down nuts securing the other two flange
keepers. See Figure 3-4.
Figure 3-4
5. Re-tighten the hardware securing the chute crank bracket.
6. Check that the chute cables are properly routed through
the cable guide on top of engine shroud. See Figure 3-5.
Figure 3-5
Chute Crank
Bracket