Table of Contents
Advertisement
INSTALLATION
• Appliance must be installed only by a
licensed gas fitter or plumber.
• This appliance must not be modified.
• This appliance must be mounted on a
surface such as stainless steel, ceramic
tiles or a similar non-combustible material
only. The appliance must not be mounted
directly on to other surfaces such as
Laminex, plastic or timber.
SAFETY INSTRUCTIONS
Ensure that all instructions are read and
understood by the owner and licenced gas
fitter/plumber prior to the installation of the
appliance and that all warnings and markings
on the appliance and owner's manual are
followed.
• Never install a damaged or faulty appliance
– return for repair or replacement.
• Inspect data plate for correct gas type
suitable for the appliance.
• Check that the gas inlet connection is free
from damage or blockages.
• Check that there is sufficient stability and
ventilation for the appliance to operate
correctly, safely and efficiently.
• The appliance must be operated on a firm,
level and non-combustible surface.
• Ensure appliance is installed in a position
where all minimum clearances are
recognised and adhered to.
CLEARANCES
This appliance must be installed so a
vertical clearance of at least 600mm is
maintained between the burners and
any combustible material.
Where this is not practical the underside of any
combustible material with a vertical clearance
of less than 600mm above the burner should
be protected by a surface material at least
6mm thick. This is then covered in sheet
metal of not less than 0.4mm in thickness or
protected by an equivalent material extending
at least 225mm beyond the sides of the cooker.
In either case the vertical clearance above the
burner should not be less than 450mm.
Rangehood
600mm
or more
225mm
or more
Side Clearance
The minimum clearance from the appliance to
the rear or sides of all combustible surfaces
A
must be no less than 225mm. When the
appliance is installed abutting a side or rear
surface the surface must be made of non-
Front
combustible materials such as ceramic tiles
or glass splash backs. If the surrounding
surfaces are constructed with a combustible
material, contact your local Gas Authority for
information on clearances required.
• Remove the appliance from its packaging
and discard all packaging materials
• Locate appliance in selected location and
ensure that gas connection point on the
rear of the appliance is easily accessible
once it is installed
• Connect the appliance to the gas hose and
regulator assembly, ensuring that there are
no twists or kinks in the hose and that all
connections are tightened with a spanner
• Check for leaks with soapy water
companionleisure.com.au
Rangehood
600mm
or more
225mm
or more
Rear Clearance
B
D
C
Side
Rear Gas Con
Advertisement
Table of Contents
