3Rd Driven Gear Assembly - Suzuki 1980 GSX400 Service Manual

• When mounting circlip, pay attention to
the direction of the circlip.
Fit it to the
side where the thrust is as shown in the
figure.
3RD DRIVEN GEAR ASSEMBLY
When mounting the 3rd driven gear on the
drive shaft, insert lock washer No. 2
into the
drive shaft, and turn it to fit it into the groove.
Then, fit the lock washer No. 1
c
in the
lock washer No. 2.
• Install the
two drive
shaft
oil seals,
positioning each as shown.
• Place two "C" rings (fj and knock pin
@J
and install drive and counter shafts.
17 GSX400E ENGINE
• Be sure to install the bearing dowel pins
®
in the locations indicated.