Rear Drive Shaft Installation - Linhai LANDBOSS LH800U-2D Service Manual

CHAPTER 4 FINAL DRIVE
2014.0
3. Pull the rear drive axle straight out of the frame.
Use short sharp jerks to free the circlip from the
gearcase. The circlip holds the axle in the
gearcase.
4. Inspect the axle splines and cv boots for any
damage.

4.12 REAR DRIVE SHAFT INSTALLATION

1. Install a new circlip onto the rear drive shaft.
Apply Anti-Seize Compound onto the rear
driveshaft splines (both ends).
2. Reinstall the rear driveshaft into the rear
gearcase. Be sure the circlip is securely fit into
the rear gearcase. Use a rubber mallet to tap on
the outboard end of the driveshaft if necessary.
3. Slide the rear drive axle into the knuckle.
LH800U-2D SERVICE MANUAL
CHAPTER 4 FINAL DRIVE. 4- 11