Switching Components On And Off Using The 12 Volt Trigger; Plugging In The Receiver - Pioneer SC-LX88 Operating Instructions Manual

03

Switching components on and off using the 12 volt trigger

You can connect components in your system (such as a screen or projector) to this receiver so that they switch
on or off using 12 volt triggers when you select an input function. However, you must specify which input func-
tions switch on the trigger using the The Input Setup menu
ponents that have a standby mode.
12V TRIGGER
INPUT
12V TRIGGER
1
2
( OUTPUT 12 V
TOTAL 150 mA MAX )
% Connect the 12 V TRIGGER jack of this receiver to the 12 V trigger of another component.
Use a cable with a mono mini-plug on each end for the connection.
After you've specified the input functions that will switch on the trigger, you'll be able to switch the component on
or off just by pressing the input function(s) you've set on
Note
! The 12V trigger can be associated not only with switching of the input function but also with switching of the
HDMI OUT terminal. For details, see HDMI Setup

Plugging in the receiver

Only plug in after you have connected all your components to this receiver, including the speakers.
CAUTION
! Handle the power cord by the plug part. Do not pull out the plug by tugging the cord, and never touch the
power cord when your hands are wet, as this could cause a short circuit or electric shock. Do not place the
unit, a piece of furniture, or other object on the power cord or pinch the cord in any other way. Never make a
knot in the cord or tie it with other cables. The power cords should be routed so that they are not likely to be
stepped on. A damaged power cord can cause a fire or give you an electric shock. Check the power cord once
in a while. If you find it damaged, ask your nearest Pioneer authorized independent service company for a
replacement.
! Do not use any power cord other than the one supplied with this unit.
! Do not use the supplied power cord for any purpose other than that described below.
! The receiver should be disconnected by removing the mains plug from the wall socket when not in regular use,
e.g., when on vacation.
! Make sure the blue u STANDBY/ON light has gone out before unplugging.
1 Plug the supplied power cord into the AC IN socket on the back of the receiver.
2 Plug the other end into a power outlet.
on page 52 . Note that this will only work with com-
12V TRIGGER
1
2
(OUTPUT 12 V
TOTAL 150 mA MAX)
page 52 .
on page 75 .
47
Connecting your equipment