Wiring; Stereo Dsp Off; 接上一页; 关闭立体声Dsp模式 - Crown XTi 1002A Operation Manual

XTi2.5 Series Power Amplifier

5. Wiring

5.1 Stereo DSP Off

This is the default mode the amplifier is set to from the factory. The amplifier is configured for stereo mode with all
processing disabled.
2. Connect Left/Right signal source to Channel 1 and Channel 2 using the XLR connectors.
3. Connect a speaker to each channel output using Speakon®, Banana Plugs, or bare wire.
WARNING: Before you start to set up your amplifier, make sure you read and observe the Important Safety
Instruc tions found at the beginning of this manual.
Operation Manual
XTi2.5 系列功率放大器
5. 连接
（接上一页）
5.1 关闭立体声DSP模式
此模式为功放的出厂默认设置。此功放在此模式下为立体声模式，且禁用所有处理功能。
1.
使用XLR连接接口将连接左/右信号源连接到通道1和通道2。
2.
使用Speakon ® 香蕉插头或裸线将扬声器连接到每路通道输出上。
警告：在您设置功放前，确保您已仔细阅读并注意本手册中提到的重要安全信息。
操作手册
9