Table of Contents
Advertisement
Eco-65 Installation and Operation Manual
6.5 Shutting Down Procedure
To turn your stove off, press the
button on the control panel until the LED light is in the
OFF position. The cooling cycle will take a few minutes and the blowers will continue to
function while the stove is cooling down.
IMPORTANT: DO NOT DISCONNECT THE POWER CORD TO TURN OFF THE STOVE.
6.6 Operating the Stove Using a Thermostat
A thermostat may help you maintain a constant house temperature automatically (See
APPENDIX B: Thermostat installation (AC05558)). A Low voltage thermostat is required. A
fixed wall mount or hand held model can be used.
To use this mode, the
button must be pushed to "Thermostat" upon starting the stove.
The heat setting is then selected using the
selector "+ or –". When set in
thermostatic mode, the stove will automatically run at the heat level selected until the set
room temperature is reached. When that occurs, the stove will switch to heat setting #1
(lowest) until the thermostat calls for heat again. The convection blower will also slow to its
lowest speed. When the thermostat calls for heat again, the stove will increase its feed rate to
match the heat setting previously selected.
If the room temperature remains stable and the thermostat does not call for heat during at
least 45 minutes, the stove will shut down. When the thermostat calls for heat again, the
stove will start an ignition cycle. Once the ignition cycle is completed, the stove will increase
its feed rate to match the heat setting selected.
6.6.1 Pilot Mode Selection
It is possible to change the setting of your unit such that if the thermostat does not call for
heat after 45 minutes, the unit will remain at the lowest heat setting (#1) but will not shut
down (this is the PILOT ON mode). The stove will remain at the lowest heat level until the
thermostat calls for heat again. It is also possible that the unit shuts down as soon as the
thermostat stops calling for heat. This mode is called "PILOT OFF".
If you prefer that your
unit runs following one of these logics, you need to change the setting to PILOT ON or
PILOT OFF by simultaneously pressing the following two buttons on the PC Board for a
couple of seconds:
and
Once you do that, the letters P, I, L, O, T, O, N will appear on the PC Board to let you know
that you are in the "PILOT ON" mode. By pressing again the two buttons, the letters P, I, L,
O, T, O,F,F will appear on the PC Board to let you know that you are in the "PILOT OFF"
mode. If you wish to go back to the default thermostatic mode (i.e. the unit shuts down after
45 minutes if the thermostat does not call for heat), simply press the same two buttons again
for a couple of seconds. The letters P, I, L, O, T, A, U, T, O will appear on the PC Board to
let you know that you are in the "PILOT AUTO" mode.
32
Hide quick links:
Advertisement
Table of Contents
