Accelerator Pedal; Master Cylinder; Fuse Block; Run - Tow/Maintenance/Storage Switch - Cushman 626501 Owner's Manual

INTRODUCTION
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.

7. Accelerator Pedal

Unintentional movement of the accelerator pedal may cause the vehicle to move which could
result in severe injury or death.
3
If the vehicle is equipped with factory installed custom accessories, some accessories remain operational with the key switch in
the 'OFF' position.
With the key switch 'ON', depressing the accelerator pedal starts the engine. When the pedal is released, the engine
will stop. To stop the vehicle more quickly, depress the brake pedal.
8. Brake Master Cylinder
The brake master cylinder is located under the first forward facing seat bottom on the driver side of the vehicle. The
fluid level must be maintained between the MIN and MAX lines on the master cylinder.

9. Fuse Block

The fuse block is used to provide electrical protection to some of the electrical items and vehicle accessories.

10. Run - Tow/Maintenance/Storage Switch

The Run/Tow switch is used when the vehicle has become stalled or inoperative.
To reduce the possibility of severe injury or death resulting from loss of vehicle control, consider
the grade of the terrain the vehicle is on and set vehicle's park brake accordingly before switch-
ing the Run - Tow/Maintenance switch to the 'Tow/Maintenance' position. When in the 'Tow/
Maintenance' position, the Anti-Roll Back and Walk-Away safety features of the system no lon-
ger function.
Before attempting to tow vehicle, move the Run-Tow/Maintenance switch to the 'Tow/Maintenance' position. Failure
to do so will damage the controller or motor.
Before disconnecting or connecting a battery, or any other wiring, move the Run-Tow/Maintenance switch to the
'Tow/Maintenance' position.
After connecting a battery, or any other wiring, wait a minimum of 30 seconds before moving the Run-Tow/Mainte-
nance switch to the 'Run' position.
The Run/Tow switch should always be returned to the 'TOW' position after moving a stalled vehicle. If the switch is left in the
'RUN' position for an extended period of time, it will drain the batteries.
The Run/Tow switch is located under the seat on the passenger side of the vehicle.
With the switch in 'TOW/MAINTENANCE' position:
• the controller is deactivated
• the electronic braking system is deactivated which allows the vehicle to be towed or roll freely
• the warning beeper is deactivated
With the switch in 'RUN' position:
• the controller is activated
3 - 4