Kurzweil Forte Getting Started Manual page 7

Pedals are all independently assignable within each Zone of every Multi.
On the back panel the Pedals are labeled as SWITCH 1/2/3, corresponding to the SW 1/2/3
labelling on the top panel. In this manual the Switch Pedals will be referred to as per the top
panel (SW1, SW2 and SW3)
Here are the default control settings for the five pedals used by the Forte:
Switch Pedal 1 (SW1)
Switch Pedal 2 (SW2)
Switch Pedal 3 (SW3)
CC Pedal 1 (CC1)
CC Pedal 2 (CC2)
The SW1 (Sustain), SW2 and SW3 Jacks
Use the pedal jacks to connect switch pedals. A switch pedal is a physical controller typically
used to control two-state (i.e., "on / off") parameters, such as sustain, sostenuto, soft and Mute
Zone.
Sustain (MIDI 64)
Sostenuto (MIDI 66)
Soft (MIDI 67)
Expression (Volume) (MIDI 11)
Foot (MIDI 4)
NOTE : Do not to step on the switch pedals when powering up the Forte,
as the state of the pedal is detected as part of the power up sequence.
The Rear Panel
The Pedal Jacks
GS-5