Setting Warmer Drawer Controls - Kenmore C970-44183 Use & Care Manual

Setting Warmer Drawer Controls (cont'd)
To Set the Warmer Drawer & Bread Proof Controls:
The control and indicator lights for the Warmer Drawer Bread Proof features are
located on the control panel. The temperatures are approximate, and are
designated by HI (high), MED (medium) and LO (low) and BREAD PROOF.
1. Touch the pad at the Warmer Drawer control position. The Warmer
Drawer indicator light will flash. Note: If no further pads are touched within 25
seconds the request to power the Warmer Drawer ON will clear.
2. Set the desired power level. Touch
HI (see Figure 2) or
The Warmer Drawer indicator light located above the ON/OFF pad will turn
ON steady.
3. Each touch of the
power levels from HI (see Figure 2) to MED (see Figure 3) to LO (see Figure
4) and to the Bread Proof feature (see Figure 5). If the Warmer Drawer is set
at the LO setting and the
and indicator light will be set (see Figure 5 and bread dough preparation
instructions on this page). To return to standard Warmer Drawer setting touch
pad at least once. Note: For best results, preheat the Warmer Drawer
before adding the food or bread dough. An empty drawer will preheat in
approximately 15 minutes.
4. When the food is ready for removal, touch the
Warmer Drawer or bread Proof feature OFF. The Warmer Drawer indicator
light will turn OFF.
Preparing Bread Dough for the Warmer Drawer
The Warmer Drawer has a Proof Bread feature that can be used to
help prepare bread dough. The recommended length of time to
keep bread dough in the Warmer Drawer is about 45-60 minutes.
Be sure however to follow the recipe's recommended times.
The unrisen bread dough should be placed in a large bowl since
the dough will nearly double in volume. Before placing in the
Warmer Drawer, cover the bowl with a moist cloth or use wax
paper that has been coated with a non-stick type cooking spray
(see Figure 6). Place the bowl in the Warmer Drawer and follow
the Warmer Drawer and Bread Proof Control setting instructions at
the top of this page.
Note: The Warmer Drawer is inoperable during the self-clean
cycle.
once to turn ON the power level for
to turn ON the power level for LO (see Figure 4).
or pads will decrease or increase through 6
pad is touch again the Bread Proof feature
pad once to turn the
17
Figure 1
Figure 2 Figure 3
Figure 4
Figure 5