Panasonic K-EW114L01E Operation Manual page 35

Enable You can use ARP/Ping command to modify or set the device IP
ARP/Ping to set address if you know the device MAC address.
IP address
Before the operation, please make sure the network camera
service.
and the PC in the same LAN. This function is on by default.
You can refer to the steps listed below.
Step 1: Get an IP address. Set the network camera and the PC
in the same LAN.
Step 2: Get the physical address from the label of the network
camera.
Step 3: Go to the Run interface and then input the following
commands.
Step 4: Reboot the device.
Step 5: You can see the setup is OK if you can see there are
output information such as "Reply from 192.168.0.125 ..." from
the command output lines. Now you can close the command
line.
Step 6: Open the browse and then input http://<IP address>.
Click the Enter button, you can access now.
arp –s <IP Address> <MAC>
ping –l 480 –t <IP Address>
Such as：arp -s 192.168.0.125 11-40-8c-18-10-11
ping -l 480 -t 192.168.0.125
32