Canon mg6850 series Online Manual page 968

1304
Cause
Paper is jammed during automatic duplex printing.
What to Do
If the paper is jammed when performing automatic duplex printing, remove the paper by following these
steps.
Note
• If paper becomes jammed during printing and you need to turn off the machine to remove it, press
the Stop button to stop the printing before you turn off the machine.
1. Pull out paper slowly from paper output slot.
Hold the paper with both hands, and pull it out slowly so as not to tear it.
2. Reload paper and tap OK on machine's touch screen.
If you were not able to remove the paper in step 1:
Follow the procedure below to remove the paper from the transport unit.
2. Turn off machine and unplug it.
3. Stand machine up on its right side.
Important
• Make sure the document cover is closed before you stand the machine up on its side.
• Stand the machine on a wide and flat surface such as a desk.
• Hold the machine securely with both hands to stand it up, being careful not to hit anything.
4. Push open lever to open transport unit.
Support the machine with your hand so that it does not fall over when you open or close the transport
unit.
968