V. Comfort Adjustments - Pride Quantum 1121 Owner's Manual

V . C O M F O R T A D J U S T M E N T S
8. Reinstall the retaining clip into each seat tower.
9. Reinstall the seat.
10. Plug the controller connector(s) into the electronics
tray.
NOTE: Make sure the seat latch safety is flipped down
before using the power chair seat.
Seat Position Adjustment
You can move the seat forward or rearward by changing
the extrusion mounting position.
To change the position:
1. Turn off the power top the controller.
2 Remove the seat.
3. Remove both extrusions from the bottom of the seat.
See figure 10.
4. Reposition the extrusions on a different set of
mounting holes. You must move both extrusions the
same number of holes either forward or rearward. See
figure 16.
5. Fasten the extrusions back onto the bottom of the seat.
6. Reinstall the seat.
Manual Recline Seatback Adjustment
If your power chair is equipped with a reclining seat, you
can adjust the seatback angle with the seatback release
lever. The lever is located on the right side of the seat base.
To adjust the seatback angle:
1. Pull up on the seatback release lever.
2. Move the seatback down or up to the desired position.
3. Release the lever.
Seatback Angle Adjustment
If your power chair is equipped with an adjustable seat-
back, you can adjust it to four (4) different angles: 90°,
102°, 105°, or 107°.
To adjust the seatback angle:
1. Remove the seatback angle adjustment screws on both
seat hinges. See figure 17.
2. Set the seatback at the desired angle.
3. Reinstall the screws to both seat hinges and tighten.
20
Figure 16. Seat Position Adjustment
www.pridemobility.com Quantum 1121