Iv. Assembly - Pride Quantum 1121 Owner's Manual

To install the seat:
1. Set the seat towers to the desired height. To change
the seat height, see V. "Comfort Adjustments."
2. Tilt the seat back, and slide the rear extrusion onto
the rear trapeze bar.
3. Lower the front extrusion onto the front trapeze bar
until the seat locks into place..
4. Flip the seat latch safety down.
WARNING! Make sure the seat latch
safety is flipped down before using
your power chair.
5. Install the controller into one of the armrests. See
V. "Comfort Adjustments."
6. Plug the controller cable(s) into the connector on
the electronics tray.
7. Route the cable to ensure that the cable cannot be
pinched in the seat hinge. See figure 12 or 13.
8. Secure the controller cable to the armrest receiver
with one or more wire ties. See figure 12.
MANDATORY!
harness damage! Avoid routing the
controller harness on the outside of
the armrest pad. Route the harness
under the armrest or toward the inside
of the armrest pad. Use correct tie-
down points for the controller harness
to prevent the harness from getting
caught in the drive tires, pinched in the
seat frame, or damaged when passing
through doorways.
18
I V . A S S E M B L Y
Prevent controller
www.pridemobility.com
Figure 12. Cable Routing - Contour Seat
Figure 13. Cable Routing - Synergy Seat
Quantum 1121