Advertisement
● Side Panels
CHANNEL 1, 2 & 3 XLER INPUTS: Connect the 3-pin XLR output of a microphone, wireless receiver or line level audio com-
ponent to CH 1 and/or CH 2 and/or CH 3. Push the XLR connector into the input jack un!l it locks. To remove the XLR con-
nector, press the "PUSH" tab while pulling the connector out.
INPUT LEVEL SELECTOR: The following 2 se"ngs are available for each channel:
MIC HI: maximum +4dBu (2kΩ)
PHANTOM DC 48V SWITCH: Each channel has its own phantom DC 48V power se"ng. When using a dynamic micro-
phone, make sure that the corresponding phantom DC 48V switch is in the OFF posi!on. When using the condenser micro-
phone that requires 48V DC external power, turn the corresponding phantom DC 48V switch ON. When you turn the phan-
tom DC 48V switch ON or OFF, make sure to turn the volume level control knobs (
OFF.
POWER SWITCH
CHANNEL LEFT & RIGHT XLR OUTPUTS: Connect a cable from these outputs to the MIC or LINE input of your cam-
era or audio recorder. The outputs accept a standard 3-pin female XLR connector.
STEREO MIC OUTPUT: This mini-connector (3.5mm) output is designed for video cameras or audio recorders with mini-
connector mic-level inputs. This output is stereo (dual-channel) and unbalanced. It is recommended to use a stereo-to-
stereo mini cable (not included) to connect this output to the input of your video camera or audio recorder. Because the
FMX-32a is equipped with low-impedance XLR inputs and a mini-connector output, users of cameras/audio recorders with
mini-connector inputs can now use high-quality microphones with XLR outputs.
MONITOR PHONES OUTPUT JACK: A 1/4" (6.3mm) jack for headphones.
LEVEL VOLUME CONTROL: Controls the volume level of the monitor phones output ( ). Zero is the lowest and 10 is the
highest se!ng.
EXTERNAL DC IN CONNECTOR: To power the mixer with external 12V DC power. An op"onal AC adaptor, part number BC
-27, is available. For informa"on, visit www.azdencorp.com
MIC LO: maximum -15dBu (2kΩ)
3
) zero or turn the power switch ( )
Advertisement
