Panasonic U-72MF2U9 Installation Instructions Manual page 50

Auto Address Setting from the High-spec Wired Remote
Controller (CZ-RTC3 / CZ-RTC5)
1 Keep pressing the
simultaneously for 4 or more seconds.
The "Maintenance func" screen appears on the LCD
display.
2 Press the or
If you wish to see the next screen instantly, press the
or button.
Select "9. Auto address" on the LCD display and
press the button.
Maintenance func
9. Auto address
10. Set elec. consumption
11. Set touch key
12. Check touch key
Sel. Page [
3 The "Auto address" screen appears on the LCD
display.
Change the "Code no." to "A1" by pressing the
or button.
Auto address
Code no.
A1
Sel. Next
Auto Address Setting* from the Remote Controller (CZ-RTC4)
* Auto address setting in Cooling mode cannot be done from the remote controller.
N OTE
● Selecting each refrigerant system individually for auto address setting
● Auto address setting for each system: Item code "A1"
1 Press and hold the remote controller timer time
and button simultaneously for 4 seconds or longer.
2 Next, press either the temperature setting
Check that the item code is "A1".
3 Use either the button to set the system No. to perform
auto address setting.
4 Then press the button.
Auto address setting for one refrigerant system begins.
When auto address setting for one system is completed,
the system returns to normal stopped status.
<Approximately 4 – 5 minutes are required.>
During auto address setting, "
the remote controller. This message disappears when auto
address setting is completed.
5 Repeat the same steps to perform auto address setting for
each successive system.
, and buttons
button to see each menu.
20:30 (THU)
] Confirm
20:30 (THU)
O/D unit no.
1
/
" is displayed on
[ ]
4 Select the "O/D unit no." by pressing the
button.
Select one of the "O/D unit no." for auto address by
pressing the
Approximately about 10 minutes are required.
When auto address setting is completed, the units
return to normal stopped status.
button
button.
2
1
50
20:30 (THU)
START
CZ-RTC3 / CZ-RTC5
or button.
4
CZ-RTC4
or
4
3